Using clips permits movement in the valley as temperatures change.
Slate roof valley flashing.
Brent ulisky of ulisky slate demonstrates flashing a closed valley at the 2015 slate roofing contractors association 10th anniversary conference near grove.
For roof pitches of 6 or more per foot the flashing extends at least 9 under the roof covering on each side.
Missing ice water shield.
Next step is to install your starter course slate.
As this weak spot on your roof directs large amounts of water it is a common source for leaks.
Roof valley flashing material options there is a lot of misinformation and confusion out there when it comes to properly waterproofing roof valleys.
Diagonal cuts can be made to the top corner of these slates in the valley so the pointy edge does not damage the metal.
Made with premium steel 28 gauge limited lifetime paint warranty easy to cut.
Valley flashing is used for flashing where roof valleys are constructed.
Intersecting roofs using a closed valley must have the same slopes so that the shingle butts line up at the valley intersection.
The cleats accommodate thermal movement in the valley flashing to prevent stress cracks.
Install an underlayment centered in the roof valley.
The first step to installing an open valley is to cleat your valley metal in.
Common causes of roof valley leaks.
For example in metal roofing systems valleys are commonly fabricated with hems but can also be fabricated without them in which case they could still be used for metal roofing or any other type of roofing.
Apply an approximately 3 inch width of asphalt roofing cement along the sides of flashing and embed shingles in mastic.
Use roof valley cleats at intervals of 24 o c.
For roof pitches less then 6 per foot the flashing extends at least 12.
Whether for slate shingle or metal roofing valley flashing adds detail and helps to direct water.
There are many factors that can contribute towards a failure of a roof valley flashing.
These items can be fabricated in many different profiles.
The installer fabricates simple clips or valley flashing cleats whose bent edge interlocks with the folded over or hemmed edges of the metal roof valley flashing to secure the valley to the roof deck.
A properly flashed roof valley should have an ice and water shield installed with roofing felt being properly secured over the ice and water.
Then install a non corrosive metal valley flashing of 24 minimum width.
